How to properly measure for your Milt Sparks Belt

Lay your belt out flat and from where the leather folds at the point where the buckle is attached, measure to the hole that you are now using.

Please remember when ordering to take into account any holster or accessory that will be worn in the waistband and add extra length as needed. We at Milt Sparks, will not be held responsible for inadequate measurements that are provided to us, that do not take into account the intended use of the belt. Any extra length that is needed, is to be determined by you according to your specific needs. Up to 2 inches of extra length will usually suffice for an inside the waistband holster, but there is no set formula for determining that factor as everyone can be a bit different.

The most accurate method of determining the proper length is to take a measurement with the actual gear you will be carrying in place. If you don't already have an IWB holster, you can always tuck your un-loaded weapon into the waistband, at a point slightly behind where your pelvic bone juts out, or at about 3 to 4 O'clock. With your belt in place over the gun, take note of which adjustment hole you are now in and measure your belt as described above. The same instructions would apply to any other accessories you may wish to carry. The measurement that you provide to us will be the center hole on your new belt.

Please feel free to give us a call for any clarification you may need on how to measure.