5345 Results Found. Displaying Results 3201 - 3225
Mark Harelson, about H&K VP9L Slide Conversion Kit
Apr 22, 2019
The adjustable rear sight and fiber front site make for quick and accurate aiming. The real joy of this long slide is the recoil control. The weight and extra length allows for quick recovery and accuracy without feeling front heavy. A quick swap at the range line and your EDC becomes a target banging dream.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Rick D, about Sig Sauer Hammer Reset Spring - P239
Apr 22, 2019
Top Gun Supply had the small hammer reset spring that broke on my pistol in stock and and it was in my mail in less than 4 days!! I can always rely on Top Gun supply to come to my aid for most all parts I might need and at a reasonable price!
Thanks again Top Gun!!

Was the above review useful to you?
Yes (
0)
/
No (
0)

Willard James, about SIG P220 .45 PARTS KIT
Apr 22, 2019
Purchased this kit for a P220 Carry recently acquired. When buying used firearms, you never know how many rounds hs been through it. Sig recommends replacing the Recoil Spring every 5000 rounds, and normally it's a good idea to thoroughly clean and inspect, that's where the other parts come in handy, as it allows you to clean and check the firing pin and channel. Also with the P220 kit you get Recoil springs for both the standard 4.4" barrel/slide assembly, and the 3.9" barrel and slide assembly. Pins for both the Original German Carbon Steel Slides, Inner/Outer, and also the current pin for the milled stainless slides. The Decocking Lever Spring, Slide Catch Lever Spring, and Trigger Bar Spring, may not be needed immediately, but high use springs that re always good to have on hand. New Grip Screws and Washers round out the package. The kit is priced well below the sum of all the parts, a real bargain. I try to keep one on hand for each of my Sigs, as they can come in handy.

Was the above review useful to you?
Yes (
45)
/
No (
0)
Ryan , about Gun Cleaning Armorer's Mat
Apr 21, 2019
This Armorers Cleaning Mat is both educational and functional. I feel smarter each time I clean with it.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Dan, about Sig Sauer P365 9mm 12RD Magazine - Extended Capacity
Apr 21, 2019
These mags are extremely hard to put 12 rounds into. When finally loaded with the help of a maglula, the mag has to be slammed into the pistol. After slamming into the pistol, it won't allow the slide to be racked.
Sig Customer service was no help. They said to load up the mag and let it sit for a week or so to let the spring settle down. I did as suggested and it's been 2 weeks and still have the same problem. When I told CS I wanted a replacement, I was told that they couldn't guarantee that the replacement would be any better.

Was the above review useful to you?
Yes (
3)
/
No (
3)
Daniel Johnson, about Beretta 92 9MM 15RD Magazine
Apr 21, 2019
Arrived quickly and in fine condition. Haven't run them yet but they're factory Beretta so I don't expect problems. Not been free to purchase these standard capacity magazines here in CA for a while so happy to have more of these.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Andrew Gonzales, about Sig Sauer P232 Grips, Black Polymer
Apr 21, 2019
Brad and the team at Top Gun Supply are consummate professionals. I wouldn't hesitate to do business with them again. I was very pleased with the service and products provided by Top Gun Supply.

Was the above review useful to you?
Yes (
0)
/
No (
0)
David, about Sig Sauer SIGPRO 2022/2009 9mm 17RD Magazine
Apr 20, 2019
I purchased two original sig sp2022/2009 17 round magazine and the finished products are top notch. Would I recommend this site to a friend? Yes! Super fast shipping. The magazines were delivered 2 days earlier than the delivery date. I would definitely do business again with Top Gun in the near future.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Abel Torres, about Glock 17 9mm 17RD Magazine
Apr 19, 2019
Great service and fast shipping. I have made purchases in the past from TGS and will continue to in the future.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Shawn Barefield, about Sig Sauer Trigger Bar Spring - P320/P250
Apr 19, 2019
Needed a replacement spring for my p320, looked online and found topgunsupply.com. Called and ordered on Monday and by Thursday my springs arrived and I installed it after the second attempt lol. Thank you topgunsupply.com this will be the first place I look when looking for replacement parts for my needs.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Mark Matthews, about Grayguns HK USP, HK45 Short Reset System
Apr 18, 2019
The Short Reset System has been the single best upgrade to my USP. It removed all the slack from the reset and take-up in single-action mode, shortened the reset distance, and made the single-action trigger pull FAR better than the factory match trigger kit. I cannot recommend this highly enough!
It does not come with instructions, so understand in advance that the roll pin that comes in the kit is to replace the slightly-shorter roll pin in the sear (easily replaced in about 10 seconds with a hammer and roll-pin punch), and the spring is to replace the firing pin block spring in the slide (which lightens trigger pull by about 1lb.

Was the above review useful to you?
Yes (
4)
/
No (
0)
Ollie Barry, about Mec-Gar P226 X5 .40/.357 14RD magazine - AFC
Apr 18, 2019
Item was as described, very quality product. The baseplates don't quite fit as well as the one that came with the gun. Its just a tad thicker which means you really have to smack them it to get them to lock in place. I'm hoping i do some light sanding to remedy that. There also a little shorter from to back. This was obvious to me in the picture but I can live with that. Overall very nice and very fast shipping.

Was the above review useful to you?
Yes (
3)
/
No (
0)
Arnel Flandez, about Mec-Gar P226 9mm 18RD magazine - FLUSH FIT - AFC
Apr 18, 2019
Outstanding Magazines for my Sig Sauer P226 Mk.25. Same dimensions as the STD Sig Sauer P226 OEM Magazines but with 3 Rounds more capacity? Done deal. Mec-Gar are known for their quality for other Firearm Manufacturers. You can't beat the price for these High Quality Magazines. Another satisfied customer!

Was the above review useful to you?
Yes (
0)
/
No (
0)
Eugene Hardy, about XD 45 ACP 13 Rd Magazine and XDM 45
Apr 18, 2019
Great company selling great products at excellent prices with super fast shipping. I thank you very much. I will be ordering more items from Top Gun Supply

Was the above review useful to you?
Yes (
0)
/
No (
0)
Timothy Franks, about Mec-Gar CZ-75 9mm 17rd - AFC
Apr 17, 2019
Top Gun Supply is a good business that believes in the principles that this country was founded upon. God bless Brad, and God bless Top Gun Supply! Fast shipping, great communication, professional operation effectively supporting customers needs.

Was the above review useful to you?
Yes (
0)
/
No (
0)
Christian Heckenbach, about Mec-Gar P228/229 9mm 15rd magazine- BLUE
Apr 17, 2019
Mec-Gar mags are OEM to many firearms, these are the same ones. Great service from Top Gun and Brad. Great product, great store!!!
Thanks Brad...

Was the above review useful to you?
Yes (
0)
/
No (
0)
Michael Pellegrino, about Beretta 92 9MM 15RD Magazine
Apr 17, 2019
Excellent service. Received my order in 2 days. Will definitely order from them again.

Was the above review useful to you?
Yes (
0)
/
No (
0)
liam kelly, about Sig Sauer P226 .40/.357 15RD magazine
Apr 17, 2019
The SIG 226 mags work great! Thank you for the ability to buy during Freedom Week. Fly high Top Gun!

Was the above review useful to you?
Yes (
0)
/
No (
0)
Ron Burnside, about Mec-Gar P226 9mm 18RD magazine - FLUSH FIT - AFC
Apr 17, 2019
Ordered two 18 round magazines for my P226. These mags are perfect fit and quality for my gun. Exactly what I expected and shipped fast. Great product !!!

Was the above review useful to you?
Yes (
0)
/
No (
0)
Anthony Mendoza, about Mec-Gar CZ-75 9mm 17rd - AFC
Apr 17, 2019
These are well-built magazines that fit right the first time and every time after. The spring is strong enough that FTF is not a concern. I keep them loaded and ready to go. What a bargain.

Was the above review useful to you?
Yes (
0)
/
No (
0)